Header Ads

SMOK MAG P3 kit Review


Both Morph 219 and MAG P3 have some of the same features. However, the Smok Mag P3 is an upgraded version and has more features than its predecessor.

Before using this product for the first time:

  • Install applicable lithium batteries follow the directions for positive and negative poles (see below).
  • Connect the power supply to the tank.
  • Make sure the set wattage is in the range of recommended wattage for coil, the version of the coil and the recommended wattage are printed at the front and back of the coil.
  • Touch or to adjust the wattage.

1. Power On


While the device is off, quickly click Fire Key 5 times in 2s to turn it on. The screen successively displays "SMOK”. (If you have set passwords, you need to input your passwords first)

2. Power off


Press the Fire Key five times until the interface displays "POWER OFF? Yes or No"; choose "Yes" to power off. Alternatively, you can touch the screen and choose "SETTING"->"GENERAL"->"Power Off" to turn off the device.

3.Vaping


1) While, the device is on, hold Fire Key to vape (it will be forced to stop working when one vaping is longer than 10s, release and press again to vape);

2) Quickly press the Fire Key 3 times to lock or unlock the vaping function.
Note: Locking the Fire key will lock the touch function simultaneously. To use the touch function again, you need to perform the slide-to-unlock to unlock the touch function.

3. Screen Unlocked and Touch Function Unlocked Status

1) Touch or to adjust the current wattage or temperature value;

2) Press Fire Key three times to lock the device (move the arrow to the right, and the screen can be unlocked.)

4. You can touch "Setting" > "Passcode" to set your own passwords.


  • Make sure the coil is tightly screwed onto the atomizer base.
  • Fill the tank completely with e-liquid (see below).
  • Take 2-3 puffs while the power is off and without pressing the Fire Key.
  • Begin vaping.
  • If e-liquid is sucked through the SMOK product into the mouth, immediately wash your mouth out completely, seek medical assistance if needed (see below), then remove the atomizer and
    clean the spillage before vaping again.


Instructions on changing the coil


After dripping e-liquid into a tank with a new coil, please stand the tank for 15 minutes to avoid the possibility of coil-burning.

Please make sure the set wattage is in the range of recommended wattage for coil using.

Replace coil head.
Screw off the base, pull out the old coil and install a new one in.

Control air input.
Rotate the adjustable airflow system to control air input.


If you have any questions about your Smok P3, feel free to contact us!

No comments

Powered by Blogger.